Phil, couple of questions for you.
What layup did you use for your daggerboards?
I hope to be rescuing some moulds, just looking for a starting point really.
Also the flip flop cleat set up you have on the top of the stump; a+e has the jib here. You have two cleats, what controls do you have here?
I have the jib sheet and kicker on a loop running to the flip flop. The downhaul and t-foil are lead to each side around the middle.
For the CB I have only made the smaller one so far, and I think the layup was
+- 45 woven 200g top 600mm or so
2* Uni 200g strip down full length approx 100mm width
uni 200g full length and full width
200g Uni approx top 500mm
+-45 woven full length