« previous next »
Pages: [1]   Go Down

Author Topic: Tata Steel Sailing Club Dinghy Open  (Read 6009 times)

0 Members and 1 Guest are viewing this topic.

Offline gav_sims

  • Former_Member
  • Newb
  • *
  • Posts: 22
  • Karma: +1/-0
Tata Steel Sailing Club Dinghy Open
« on: September 18, 2012, 01:26:45 PM »
Tata Steel (formerly Corus, formerly formerly British Steel) near Port Talbot are holding their annual dinghy open on the  6th and 7th of October (http://www.corussailing.org.uk/ ).  Fubar is considering heading east for the weekend................... forecast dependent of course and if I can source enough duct tape to reduce the porosity of the sails.
Logged

Offline Tim Noyce

  • Former_Member
  • Guru's Guru
  • *****
  • Posts: 1126
  • Karma: +44/-1
Re: Tata Steel Sailing Club Dinghy Open
« Reply #1 on: September 18, 2012, 01:32:43 PM »
Balls, I am in Betws-y-Coed that weekend otherwise I would have been bang up for that.
Logged

Offline phil_kirk

  • Former_Member
  • Guru's Guru
  • *****
  • Posts: 1722
  • Karma: +10/-2
Re: Tata Steel Sailing Club Dinghy Open
« Reply #2 on: October 10, 2012, 12:38:04 PM »
We saw Fubar strutting her stuff on Sunday.  Looked good and was going well in Gav's hands.

They were sailing off 930 so their overal positions were not so good. 

the event was very busy with very little room on the slipway and inside the dinghy pound when all boats were ashore between races.  Someone said a total of 70 boats.  I was sailing the ent in the slow fleet and came second in each race to a very well sailed streaker.  We were neck and neck all the way round and 1/2 a leg ahead of the faster wayfarers. 
Logged
Pages: [1]   Go Up
« previous next »