UK-Cherub Forum

Cherub Chat => Tech Chat => Topic started by: Banshee Ambulance on May 02, 2012, 08:44:05 PM

Title: Resin Help
Post by: Banshee Ambulance on May 02, 2012, 08:44:05 PM

Can anyone tell me more about this resin? A friend at work who used to be involved with the design and construction of snowboards gave it to me. Is it any good for boat stuff or just mould making quality?

Title: Re: Resin Help
Post by: tim_unerman on May 02, 2012, 09:10:15 PM

MY 750 is a standard Huntsman resin system, should be fine for most standard work, I might chose to use a slightly higher strength resin if I was making a mast or high load part. Be a little bit careful as the hardener is out of date and I would at least do some trials before using it on the boat.

Hope it help

Tim

Title: Re: Resin Help
Post by: Banshee Ambulance on May 02, 2012, 09:16:18 PM

Thanks for the reply. What mix ratio does this use? is it by mass or volume?