AquaMarina was made from a hull shell supplied by Bloodaxeboats and finished by Phil Alderson in Aberdeen
Bow area with false floor in place and spiniker pole lying on top.
Kingt Post, bulkheaads and centerboard case
Looking aft at the corner peices that support the top of the side decks
Looking forward with the false floor in place.
Another forward view showing the king post.
Looking down on the king post.
The workshop, this picture does not show the I14 sail that hung above the boat stopping the dirt from falling from the roof down onto the boat.
Another view aft
Looking at the transom before the gantry went on.
Close up of the one of the tubes that will make up the racks
Rack Tubes agian
Nearing completion, faired and ready for painting. The longtitudinal tubes were left off till the end to give more space in the workshop as it had now changed to a small garrage.
Rigging up for the first time at the side of a road in weymouth
The original Gantry was too close to the water and the sticky out gudgions were failure prone. So it was cut off and replaced.